What a tithi is, how it is computed, and why tithis are sometimes lost or repeated
Last updated 21 November 2026 · JinaPan
Jain observances, from the twelve monthly parva days to Mahavir Janma Kalyanak, are fixed by tithi (તિથિ, तिथि), the lunar day, rather than by the solar calendar. Knowing what a tithi actually is explains a lot of the puzzles people run into: why Atham can last only part of a day, why a panchang occasionally skips a tithi, and why two sanghs may keep the same festival on different dates.
The definition: 12 degrees of separation
As seen from Earth, the Moon moves eastward against the stars about 13° a day, and the Sun about 1° a day. So each day the Moon pulls roughly 12° further ahead of the Sun. A tithi is the time it takes for the Moon’s ecliptic longitude to gain exactly 12° on the Sun’s.
- At new moon (Amavasya ends) the two longitudes are equal: 0°.
- From 0° to 12° is the 1st tithi of the bright fortnight, Shukla Pratipada (Sud Ekam).
- 168°–180° is the 15th, Purnima (Punam), ending at full moon.
- 180°–192° begins the dark fortnight, Krishna Pratipada (Vad Ekam), and so on.
- 348°–360° is Amavasya (Amas).
That makes 30 tithis in one lunation of about 29.53 days, so the average tithi lasts about 23 hours 37 minutes. Because the Moon’s orbit is elliptical and its speed varies, a real tithi can be as short as about 19–20 hours or as long as about 26–27 hours. The Wikipedia article on tithi gives a fuller background.
How JinaPan computes it
For any moment, JinaPan asks the open-source Astronomy Engine library for the geocentric ecliptic longitudes of the Moon and the Sun and takes the difference:
elongation = (Moon longitude − Sun longitude), from 0° to 360° tithi number = floor(elongation ÷ 12) + 1, from 1 to 30
Numbers 1–15 are Shukla (15 = Purnima) and 16–30 are Krishna (30 = Amavasya). The end of the tithi is found by searching forward for the moment the elongation reaches the next multiple of 12°. Note that the difference of two longitudes is the same in the tropical and sidereal zodiacs, so the tithi does not depend on any ayanamsa.
Astronomy Engine’s authors state an accuracy of about one arcminute for Sun and Moon positions. One arcminute of elongation is about two minutes of time, so tithi end times can differ from another panchang by a minute or two. For example, for Mahavir Janma Kalyanak 2026 published panchangs give Chaitra Shukla Trayodashi ending around 6:55 am IST on 31 March; JinaPan computes 6:57 am.
Udaya tithi: the tithi at sunrise
A tithi begins and ends at any time of day, but a calendar day needs one label. The near-universal rule in Jain and Hindu panchangs is the udaya tithi: the tithi current at local sunrise names the whole day, from that sunrise until the next. That is what JinaPan shows on the Today card and in the month calendar.
Because sunrise depends on location, the same instant can give a different udaya tithi in different places. On a winter morning, a tithi that ends at 6:40 am IST is still running at Kolkata’s sunrise (around 6:15 am) and names the day there, but it has already ended before Mumbai’s sunrise (after 7 am), so in Mumbai the day takes the next tithi. This is a real cause of festival dates differing between India and abroad.
Kshaya tithi: a lost tithi
Sometimes a short tithi begins after one sunrise and ends before the next. It is never current at any sunrise, so under the udaya rule it never names a day. Such a tithi is called kshaya (ક્ષય, क्षय, “lost”). The calendar jumps, for example, from Sud 3 straight to Sud 5.
JinaPan marks such days with a small K and lists the lost tithi with its start and end times, because a kshaya tithi can still be a parva day or a festival.
Vriddhi tithi: a repeated tithi
The opposite also happens. A long tithi can begin just before one sunrise and end just after the next, so it is current at two sunrises in a row. It then names two consecutive days, and is called vriddhi (વૃદ્ધિ, वृद्धि, “increase”). JinaPan marks the first of the pair with a V.
Because there are about 371 tithis in a solar year but only 365 sunrises, kshaya tithis occur a few more times a year than vriddhi tithis.
Where traditions differ
Here is the crucial point for parva days: the astronomy is the same for everyone, but the rule for observing a lost or repeated parva tithi is not.
- When a parva tithi such as Atham or Chaudas is kshaya, some calendars observe it on the day it actually occurs (the day it starts and ends). Others hold that a parva tithi should not be lost, and instead treat the preceding ordinary tithi as kshaya, so the parva tithi gets its own sunrise.
- When a parva tithi is vriddhi, some observe it on the first day and others on the second, and again some shift the repetition to a neighbouring ordinary tithi.
- Within Shwetambar Murtipujak practice, and particularly within Tapagachchha, the handling of kshaya and vriddhi parva tithis has been the subject of a long-standing disagreement between groups of acharyas, which is why two Tapagachchha calendars can differ by a day.
JinaPan does not choose between these conventions. It shows the astronomical facts, the tithi at sunrise plus any kshaya tithi falling within the day, and flags the day so you can check your own sangh’s panchang.
The parva tithis
The tithis traditionally marked for extra discipline in Shwetambar practice are Bij (2), Pancham (5), Atham (8), Agiyaras (11) and Chaudas (14) of both fortnights, plus Punam and Amas: twelve in a lunar month. Chaudas in each fortnight is also the day of pakkhi (fortnightly) pratikraman. Digambar and other traditions emphasise some of these days differently, notably Ashtami and Chaturdashi. JinaPan highlights all twelve and leaves the specific observance to your tradition.
Summary
- A tithi is a 12° step in the Moon–Sun angle, about a day long but variable.
- The tithi at local sunrise names the day.
- A tithi that misses every sunrise is kshaya; one that spans two sunrises is vriddhi.
- Sanghs agree on the astronomy but can differ by a day on how to observe parva tithis that are lost or repeated. Follow your sangh where it differs.